How to Choose the Right Gas Strut

To choose the right gas strut you need three numbers: the extended length (eye to eye), the force in newtons, and the thread size of the end fitting. Measure your old strut or your application, and you can find a matching replacement in minutes.

Step 1: Measure the extended length

The extended length is the distance between the two mounting points with the strut fully extended, measured centre-to-centre of the end fittings. If you are replacing an old strut, measure it fully extended — even a worn strut still extends to its full length, it just loses force.

Gas struts at Ausmachine range from 90 mm up to 1,185 mm extended length, in M6, M8 and M10 thread sizes. As a rule of thumb, the stroke (how far the strut travels) is roughly 35–45% of the extended length.

Step 2: Calculate the force you need

A quick formula for a lid or flap supported by two struts:

Force per strut (N) ≈ (lid weight in kg × 9.81 × distance from hinge to centre of gravity) ÷ (2 × distance from hinge to strut mount)

In practice, most tailgates and furniture flaps need between 100 N and 400 N per strut. Heavy machine covers and canopies typically need 500–1,200 N. Our struts are available in forces from 50 N up to 1,200 N in steps of 50 N, so you can match the calculation closely.

Two practical tips:

  • If in doubt between two forces, choose the higher one for lids you want to stay open, and the lower one for lids you want to close easily.
  • Always fit struts in pairs on wide lids — a single strut twists the panel over time.

Step 3: Pick the end fitting

  • Ball socket / ball joint: the most common connection — clicks onto a ball stud, allows angular movement, quick to fit and remove.
  • Eyelet: a steel ring that bolts through a bracket — the strongest option for heavy or industrial applications.
  • Clevis fork head: a fork that pins to a flat bracket — used where the strut must pivot in one plane only.

Thread sizes follow the strut diameter: M6 fittings for 6/15 mm and 8/18 mm struts, M8 for 10/22 mm struts, and M10 for 14/28 mm struts.

Frequently asked questions

Can I use a longer strut than the original?
Only if the mounting geometry allows it — the compressed length must still fit between the mounts when the lid is closed.

My lid drops slowly — do I need more force or a new strut?
A slow drop usually means the gas has leaked. Replace the strut with the same length and force rather than fitting a stronger one.

Do gas struts wear out?
Yes — typical service life is 30,000 to 50,000 cycles. Dust protection cups and correct orientation (rod down) extend it significantly.

Browse our full range of gas struts and end fittings — quantity discounts start automatically at 2 units.